Belkin OmniView F1DP116S Manual de usuario descargar pdf (Pagina 13)

P75598- Belkin OmniView Serial Console

1. Power down the target device(s) the will be connected to your Serial Console

2. Connect the Ethernet cable to the to the port labeled LAN

3. Locate the included power cord and plug the appropriate end into the power socket on

the rear of the Serial Console. Plug the other end into an appropriate AC wall outlet.

Note: Allow about 100 seconds for the Serial Console to complete the bootup process.

4. Choose an available numbered port on the rear of your Serial Console. Plug one end

of a UTP patch cable (4-pair, up to 15 meters) into the selected port and plug the other

end into the target device. You may need to add the appropriate adapter to interface

with your target device. Please refer to Appendix ___ in this manual for more details.

5. Repeat this procedure for all target devices. (Refer to diagram below.)

Figure 1 –Cable Connection Setup- This diagram depicts sample cable connections for

different interfaces.

Network Configuration

Before you can connect to a target device you will need to configure the network settings.

The Serial Console offers two methods of setting the network: via Web browser interface

13 / 66

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 65 66

Sin comentarios

Belkin OmniView F1DP116S Manual de usuario Pagina 13