Belkin F5D7130 - Wireless G Access Point Manual de usuario descargar pdf (Pagina 15)

section

1313

Configuring the WRE/AP

Configuring as a Wireless Access Point

The WRE/AP can add wireless-enabled computers to an existing wired

network. The Access Point acts as a bridge between your existing wired

network and your wireless-equipped computers. Please be sure to follow

the steps below carefully.

1. Select a suitable place for your WRE/AP.

2. Connect an Ethernet cable between the WRE/AP and your cable/DSL

router’s LAN port, Ethernet switch, or hub.

Router, Ethernet

switch, or hub

Wireless Range

Extender/Access Point

3. Connect the power supply to the WRE/AP by plugging the round

DC connector into the DC jack on the WRE/AP. Plug the power

supply into the wall. Verify that the Power LED and the Link LED are

illuminated. If both LEDs are illuminated, the WRE/AP is connected

properly.

4. Place the WRE/AP on a desktop or mount it to a wall in the location

that you have chosen. Next, swivel the antennas so they are both

pointing up.

Connection and placement of your Wireless Access Point is now

complete!

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 56 57

Sin comentarios

Belkin F5D7130 - Wireless G Access Point Manual de usuario Pagina 15