Belkin ADSL Modem with Wireless 802.11g Router Manual de usuario descargar pdf (Pagina 17)

1514

Setting Up your Computers

section

Set up the computer that is connected to the cable or DSL modem

by FIRST using these steps. You can also use these steps to add

computers to your Router after the Router has been set up to connect

to the Internet.

Manually Configuring Network Adapters in Mac OS

up to 9.x

In order for your computer to properly communicate with your Router,

you will need to change your Mac computer’s TCP/IP settings to DHCP.

1. Pull down the Apple menu. Select “Control Panels” and

select “TCP/IP”.

2. You will see the TCP/IP control panel. Select “Ethernet Built-In”

or “Ethernet” in the “Connect via:” drop-down menu (1).

3. Next to “Configure” (2), if “Manually” is selected, your Router

will need to be set up for a static IP connection type. Write the

address information in the table below. You will need to enter this

information into the Router.

(1)

(2)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 88 89

Sin comentarios

Belkin ADSL Modem with Wireless 802.11g Router Manual de usuario Pagina 17