Belkin HI-SPEED USB 2.0 EXTERNAL DRIVE ENCLOSURE Manual de usuario

F5U210User ManualCreate a portable high-speed storage device for yourcomputer, instantlyHi-Speed USB 2.0 & FireWireExternal Drive Enclosure Kit

8Using the Hi-Speed USB 2.0 Interface:1. Insert the installation CD in your CD-ROM drive.2. Open the Install CD.3. Run “SETUP” to install the drivers

9WINDOWS 98 SE DRIVER INSTALLATIONNote: If the “Unplug or Eject Hardware” icon does not appear in the systemtray (located in the lower, right-hand cor

WINDOWS ME, 2000, XP DRIVER INSTALLATION101. If you are plugging the external drive into your computer for the firsttime when using the USB interface,

SAFE REMOVAL OF DISK FROM WINDOWS11Safe Removal of the Hi-Speed USB 2.0 or FireWire Disk from WindowsWindows 981. Click the green “Unplug or Eject Har

12FORMAT THE DRIVEFormat the External Hi-Speed USB 2.0 or FireWire DriveFormat under Windows 981. Boot up the computer into the Windows operating syst

13FORMAT THE DRIVE5. Select “Disk Drives”. Your new hard disk will appear in the hard drive list.6. Double-click on the entry for your hard drive. Sel

14FORMAT THE DRIVEDOS Method (Recommended for Advanced Users Only)1. Click on “Start” and choose “Programs”. Select “MSDOS”.2. At the DOS prompt, type

15FORMAT THE DRIVE5. In the “Change Current Fixed Disk Drive” screen, enter the disk drivenumber that is assigned to your external drive.IMPORTANT NOT

16FORMAT THE DRIVENote: If you are viewing the Control Panel in classic mode, proceeddirectly to “Administrative Tools”.2. Click on “Disk Management”.

FCC StatementDECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITYWe, Belkin Corporation, of 501 West Walnut Street, Compton, CA

TABLE OF CONTENTSIntroduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1Overview . . . . . . . . . . . . . . . .

© 2003 Belkin Corporation. All rights reserved.All trade names are registered trademarks of respective manufacturers listed. Mac OS and Mac are tradem

INTRODUCTIONCongratulations and thank you for purchasing the Hi-Speed USB 2.0& FireWire External Drive Enclosure Kit from Belkin. Your new DriveEn

OVERVIEW2System RequirementsHardware:Notebook or desktop computer with a USB 1.0 port, a Hi-Speed USB 2.0port, or an IEEE 1394 FireWire port.Operating

ASSEMBLING YOUR DRIVE ENCLOSURE31. Remove top of drive bay enclosure.2. If you are installing a 3 1/2-inch hard drive, check to make sure yourdrive is

4ASSEMBLING YOUR DRIVE ENCLOSURE4. Choose the set of mounting holes that match the drive you intend to use,and install at least four of the provided m

5ASSEMBLING YOUR DRIVE ENCLOSURE6. Hook the first side rail around front edge of the enclosure, and press the rail into the six rectangular-shaped mou

6ASSEMBLING YOUR DRIVE ENCLOSURE8. Insert the mounting tabs on the free end of the front panel into thesecond side rail, and hook the side rail onto t

7ASSEMBLING YOUR DRIVE ENCLOSURE11. Plug the rectangular-shaped connector of the USB cable into a Hi-SpeedUSB 2.0 port on your computer or Hi-Speed US